November 19, 2026 / SemiMedia / — Samsung Electronics reportedly plans separate DRAM development paths for HBM5 and mainstream memory after its D1c generation. According to The Elec, citing industry sources on November 17, Samsung will use a wafer-bonded architecture called D0A for HBM5 while retaining a conventional structure for D1d products such as LPDDR. Both target transfer to mass-production lines in the second half of 2027.
D0A would separate memory cells and peripheral circuitry onto different wafers, using D1b for the cells and D1d for the core and peripheral circuits. Joining those wafers would allow Samsung to optimize the two parts independently, rather than manufacture both within the same process flow.
Moving peripheral circuits off the cell wafer would free more of its area for memory cells. The separate circuit wafer could also use a process better suited to peripheral performance, with fewer constraints from cell fabrication. The approach targets density and circuit performance through architectural changes as well as process scaling.
Hybrid bonding is expected to connect the wafers by aligning and bonding their dielectric surfaces and copper interconnects. In this design, the bonded cell and circuit wafers together form the DRAM device.
D1d for LPDDR would continue to integrate cells and peripheral circuitry on one wafer and retain a 6F² cell layout. Samsung is also continuing work on the 4F²-based D0AV architecture with vertical channel transistors, targeting development in 2028. Its specific end products have not yet been determined.
The reported sequence would bring wafer bonding to conventional 6F² cells before the more demanding shift to 4F² cells and vertical channels. This separates the introduction of bonding from the larger cell redesign, which remains on a later development track.







All Comments (0)